TM 11-6625-2781-14&P-2
Section II
g. After the RF and IF sections are joined
b. Firmly grasp the middle part of latch flange and
pull RF/IF sections straight out.
mechanically and electrically, the complete assembly
is ready to insert in the display section mainframe.
c. Locate black press-to-release lever near left
front side of RF section.
Press this lever and
h. Pick up the RF/IF sections and center in
simultaneously exert an upward pulling force on front
opening of display section. Push forward until assembly
edge of RF section.
fits snugly into display section mainframe.
d. When the two sections separate at the front,
i. Push in front panel latch to securely fasten
raise RF section two or three inches and slide metal tab
assembly in place.
at rear of IF section out of the slot with which it is
engaged.
2-19. To separate the RF/IF sections from display
section and then to separate the RF section from the IF
section, proceed as follows:
2-20. INSTALLATION CHECKOUT
2-21. After equipping the display mainframe with the
a. Push front panel latch in direction of arrow until
plug-in RF/IF sections (Paragraph 2-17), the operation
it releases.
procedures specified in Section III should be performed.
2-2
