calibrate the dispersion to specifications, the fol-
0.75 to 1.0 volt). If the level is changed,
within
lowing techniques may be tried.
the Center Freq Range adjustment and a check for
sidebands must be repeated.
new level. (The output voltage level must remain
Interchange Q310, Q340 and Q350. The slight
differences between the transistor parameters will
have some effect on display linearity. Changing
sistors have been installed or components have
been changed and linearity cannot be obtained
by other means,
b. Apply .1 s and 10 ns markers from the Time-Mark
Generator (Type 184) through a 20 dB attenuator to band
B RF INPUT connector, Set the VERTICAL DISPLAY switch
to LOG position.
c. Adjust the Type 491 GAIN control for a display ampli-
tude of approximately 6 divisions. See Fig. 6-20. Set the
SOURCE switch to LINE and adjust the LEVEL control for
a triggered display.
NOTE
More than one set of 1 MHz markers may appear
on the display. To avoid confusion, tune the RF
align the tunable markers with the fixed (IF feed-
through markers).
Measuring
linearity.
6-21